Ansonic LP 12 Livret D'instructions page 14

7
MAINTENANCE
7.1 CLEANING OF SPAY-ROTORS
The spray-rotors can easily be removed for the periodic cleaning of the jets in order to prevent possible
obstructions.
Wash them thoroughly under running water and put them back in their correct position.
To remove the upper spray-rotor:
Unscrew anticlockwise the support of the spray-rotor.
7.2 CLEANING OF FILTERS
After each wash the filter group should be checked in order to remove possible dirt residues. Proceed
as follows:
• take out the central filter 1
• remove the external water filter 2
• take out mobile grid 3.
Clean all these components under running water. It is important to clean all filters thoroughly because
the dishwasher cannot function properly with obstructed filters.
We recommend to put the cleaned filters back in their positions immediately to avoid damage to the
wash pump.
1
7.3 CLEANING OF THE WATER ENTRY FILTER
You should also clean filter B periodically. It is located
between the water faucet and the water entry tube.
• Close water faucet A.
• Unscrew attachment piece C, take out filter B, and clean
it thoroughly under running water.
• Put the filter back in its place and screw the water entry
hose on. Check that there are no water leaks.
19
21
LA2505-180
To remove the lower spray-rotor:
Pull the spray-rotor upwards and take it out.
22
2
LA2505-190
A
B
C
20
23
3
LA2505-200
LA2505-040
1 2 3 4 5 6 7 8 9 0 1
13
1 2 3 4 5 6 7 8 9 0 1
1 2 3 4 5 6 7 8 9 0 1
GB
1 2 3 4 5 6 7 8 9 0 1
1 2 3 4 5 6 7 8 9 0 1
1 2 3 4 5 6 7 8 9 0 1