Ansonic LP 12 Livret D'instructions page 12

Pulling out the upper basket
The upper basket can be pulled out and removed
as shown in the figure.
Description of control buttons and
indication lights
(Model illustrated in fig. 18)
1) Indication programme LED
It is illuminated when the appliance is turned on.
-ON/OFF 2) On-Off buttons
On/Off – Press this button to turn on the appliance.
3) Programme selection button
4) Start-Stop/Pause programme button
5) Door handle
To open pull forward (an electric safety mechanism turns off the machine when the
door is being opened).
2
Start
After checking the quantities of regeneration salt (only in the salt container version) and of rinse aid,
open the water faucet completely, place the dishes in the baskets, fill detergent into the detergent
container and add also detergent for the pre-wash (if necessary); then close the front door.
Now proceed as follows:
• Press the "ON-OFF" button
Wash cycle selection
• When you press the button
1
flashing LED . The next times you press the button, the LED of the programme that corresponds to
the wash cycle you intend to select will light up. At the end of the cycle, the selected programme flashes.
Select the programme which you believe is best suited to the types of dishes which need to be washed.
Start Button
4
Press button with the appliance door shut, the dishwasher wash cycle will start and the LED of
the button itself lights up.
Incorrect setting of the programmes (programme change)
• To modify a wash cycle in progress, you must press the Start button
subsequently, the LED of the selected programme begins to flash. The RESET phase will end when
the Start button LED goes off. At this point, the appliance is ready to be set again.
• If you forget to put a dish in, you can interrupt the wash cycle (preferably only if it hasn't been running
for long) by pressing the Start button
dish inside. To restart the appliance, close the door and press the Start button again; the cycle will
resume from the point in which it was interrupted.
• To repeat the same cycle, press the programme button
5
2
, "The LED corresponding to the last wash cycle performed lights up".
3
for the first time, you confirm the wash cycle that corresponds to the
which then flashes; open the appliance door and place the
4
1
for approximately 6 seconds;
4
and then the Start button
3
17
18
3 4
4 .
1 2 3 4 5 6 7 8 9 0 1
11
1 2 3 4 5 6 7 8 9 0 1
1 2 3 4 5 6 7 8 9 0 1
GB
1 2 3 4 5 6 7 8 9 0 1
1 2 3 4 5 6 7 8 9 0 1
1 2 3 4 5 6 7 8 9 0 1