Product Lifetime - Protac SenSit Mode D'emploi

Product lifetime

The product's expected lifetime is five years.
The product's lifetime is based on correct use, cleaning, washing, service and maintenance.
Products that are used in excess of the above lifetime must be assessed for future use. The user
is responsible for continuously assessing whether the product can be used in excess of the lifetime
stated.
Cleaning
It is recommended to clean and wash the covers as the Protac SenSit
over time. The need and frequency of washing depend on the use of the chair.
DK
Follow the instructions below when washing and cleaning the chair.
• The cover can be washed in a washing machine, min. 7 kg, using a detergent without
GB
bleach and perfume. Fabric softener must not be used. See the washing instructions inside
the cover.
• The seat cover with incontinence fabric on the reverse side, can be unzipped and washed
DE
separately using a detergent without bleach and perfume. Fabric softener must not be used.
See the washing instructions inside the cover.
• Neck and side wings can be washed in a washing machine, min. 7 kg, using the supplied
FI
washing bags. Use detergent without bleach and perfume. Fabric softener must not be
used. See the washing instructions inside the wings.
FR
Instructions before wash:
1. Remove the innerbag from the neck support.
2. Remove the ball bags from side-/ neck wings. The ball bags must be washed separately.
NL
The included laundry bag must be used.
3. Zipp off the seat cover.
4. Detach the inner bag, with balls and granulate, from the velcro in the back and take it out
SE
of the chair.
5. Zipp off the bottom cover.
6. Unzip the chambers for the back and front-foam plates at the bottom.
ES
7. Remove the front and back foam plates.
8. Close all zippers. Zipp seat / bottom covers to the cover, before washing.
IT
Assembly after wash:
1. Unzip the seat and bottom cover.
2. Unzip the front foam plate chamber.
3. Insert the front foam plate in the chamber, remember to turn the side with the plastic
plate inward. Close the chamber with the zipper.
4. Unzip the chamber for the back foam plate.
5. Insert the back foam plate in the chamber, remember to turn the side with the plastic
plate inward. Close the chamber with the zipper.
6. Zip on the bottom cover
7. Place the innerbag inside the cover. Make sure the velcro pieces fit at the back
8 Zip on the seat cover. Attach the velcro on the seat cover to the velcro on the inner bag.
9. Insert the innerbag in the neck support, the ball bags for neck and side wings in the
chambers. Closes with zipper. Remember to attach the ball bags to the neck and side wings
inside with velcro.
14
chair may become dirty
®