Num'axes PIE1048 Guide D'utilisation page 26

Working timer
Time Lapse
Language
Cycle recording
Time & Date
PIE1048 - Indice A – Juillet 2020
In environments with lots of interference like hot wind, smoke,
near window, etc., the recommended setting is low.
ON / OFF
The camera can be set to take photos/videos only at a certain time
of the day. Each day, the camera will work only during the user set
time period. The rest of the time, the camera will be in stand-by
and will not work.
Select "ON" then press "OK" to set the start time and end time of
the desired working period (HH:MM).
Example: If the "Working timer" is set to 15:00-18:00; each day,
the camera will work only between 15h00 (03:00 PM) and 18h00
(06:00 PM).
This function can be set to "OFF" which means the camera works
all day.
The Working timer feature can work together with the Time lapse
feature.
ON / OFF
With "Time Lapse" set to ON, the camera will capture photos or
videos automatically at a preset time interval regardless of
whether motions are detected or not.
WARNING: when the Time Lapse parameter is set to ON, the PIR
sensor is deactivated.
Select "ON" then press "OK" to set the interval between the
automatic captures of photos or videos (Interval programmable
from 00 00 03 to 23 59 59 – Default time lapse: 00 00 30).
Example: if "Time Lapse" is set to 00 30 00, the camera will
automatically capture photos/videos every 30 minutes.
The Time lapse feature can work together with the Working timer
feature.
English / Deutsch / Dansk / Suomi / Svenska / Español / Français /
Italiano / Nederlands / Portugués / Chinois / Japonais
ON / OFF
Select "ON" then press "OK" to activate the cycle recording
function. When the SD card will be full, the camera will continue
to record photos/videos by deleting the earliest photos or video
clips.
Time & Date setting
20/11/2019
Time format
24 hours
15:57
12 hours
26/88