O'Barber TO30 Guide De L'utilisateur page 17

1.5 Safety instructions
The clippers are designed for use in a
hairdresser's salon, in compliance with the
following points.
Electrical hazards
Make sure that the power supply voltage
shown on the nameplate (Fig. 2)
corresponds to that of your electrical installation.
clippers immediately. Contact the dealer or his
after-sales service to obtain a replacement lead.
In the event of failure of the power pack, it must
Regularly check the condition of the
electrical lead. If the lead shows any
signs of damage, stop using the
be replaced by a model that is
identical in all respects.
The electrical lead must always be
fully unrolled before it is connected
to a power socket.
17
EN