Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.5
Safety instructions
The clippers are designed for use in a
hairdresser's salon, in compliance with the
following points.
Electrical hazards
Make sure that the power supply voltage
shown on the nameplate (Fig. 2)
corresponds to that of your electrical installation.
clippers immediately. Contact the dealer or his
after-sales service to obtain a replacement lead.
In the event of failure of the charge stand or power
pack, it must be replaced by a model that is
identical in all respects.
Regularly check the condition of the
electrical lead. If the lead shows any
signs of damage, stop using the
The electrical lead must always be fully
unrolled before it is connected to a
power socket.
17
EN
Publicité
Table des Matières
