Monacor AXC-3557PTZ Mode D'emploi page 16

5 Settings via OSD Menu
The camera settings can be changed by means
of an OSD menu which is operated via PTZ re-
mote control from the video recorder . Remote
control is made by means of the COC protocol
(COAX) via the video cable . As an alternative,
the OSD menu can be operated by means of a
control panel via the RS-485 interface; in case
of the video signal formats HD-CVI and CVBS,
this is the only way to operate the OSD menu .
When the power supply is switched on or
when the camera is restarted, the camera will
make a reference move and insert information
with regard to the camera type and the interface
settings into the image, e . g .:
S/N: 201801050046
VERSION : V1.45J
MODEL : DOME
PROTOCOL: PELCO
DOME ID : 001
BAUDRATE: 4800
To show the OSD menu, call up "Preset 95" at
the video recorder or at the control panel . As
an alternative, call up "Preset 9" twice (with-
in 3 seconds) while the start-up information is
inserted in the image to show the OSD menu .
The main menu will appear:
MAIN MENU
-------------------
-SYSTEM -
CAMERA -
FUNCTION -
INFRARED LED -
EXIT
Use the control commands for vertical move-
ments  to select a menu item . The currently
selected line is preceded by "–" . Menu items fol-
lowed by "–" include submenus . Use the control
command for movements to the right  (or the
command "IRIS+") to call up a submenu or to
activate a function . To change a setting, call up
the selected menu item with  . The line will be
preceded by "&"; the setting can be changed by
means of  .To confirm the changed setting, use
 (or "IRIS +"); to reject it, use  (or "IRIS −") .
In the submenu
submenu branch described in the menu table
☞
( pages 22 and 23), operation differs as
b
follows:
16
☞
( page 20) and in the
CAMERA
Use the control commands for horizontal move-
ments  to change the value or to select an
option . When a menu item or option is followed
by the symbol ↲ , the command "IRIS +" can
be used to call up a submenu or to activate a
function .
To exit the submenu, go to the line
select the option
SAVE&END
may have made to the settings will be saved)
or the option
NOT SAVE
rejected) and confirm with "IRIS +" .
All setting options are listed in the tables on
pages 20 – 23 . These instructions refer to the
menu in English; the language for the submenu
branch of the menu table
changed via
7. SPECIAL
5.1 Changing the camera ID/baud rate
If multiple cameras are used, the cameras re-
quire individual addresses . All cameras are fac-
tory-set to the camera ID "1" . To change the ID
of a camera, first connect only the camera to a
control panel / recorder and then use one of the
following two methods .
5.1.1 Fast setting ID 1–16
1) Restart the camera:
At the control panel/recorder, call up the
command "Preset 94" or the menu item

SYSTEM DEFAULTS
2) While the start-up information is shown, call
up – depending on the ID desired – one of
the following preset commands twice (within
3 seconds):
Preset 101 ➾ ID1
Preset 102 ➾ ID2
⋮ ⋮
Preset 116 ➾ ID16
The camera will restart and show the new ID
in the start-up information .
↲ (any changes you
↲ (any changes will be
, however, can be
b
↲ 
.
5. LANGUAGE
 .
RESTART
,
EXIT