Monacor AXC-3557PTZ Mode D'emploi page 20

a Menu line
Selection/ Submenu
SYSTEM –
Display of information with regard to camera type and to settings of the interface (analogous to information shown when the
camera is started)
DOME INFO –
BACK*
EXIT*
S/N
CONFIRM
ID SETTING –
ID
BAUDRATE
TIME
CLOCK SETTING – DATE
DAY
AUTO FLIP
PROPORTION
POWER UP RUN
AUTO RUN –
IDLE RUN –
CLEAR ALL PRESETS
CLEAR ALL PATTERNS
DEFAULTS – CLEAR ALL TOURS
FACTORY DEFAULTS
RESTART
TYPE
VIDEO OUTPUT –
SYSTEM
CAMERA – Settings of the camera image
ZM DISP
AF MODE
ZM SPEED
LENS INIT ↲
VIDEO
DEFAULT ↲
NEXT 
EXIT
*The lines BACK and EXIT are available in most submenus.
20
Setting; function
return to the higher menu level
exit the menu
serial number
to change the ID or BAUDRATE, enter the serial number here first
ID number 0 ... 1 ... 255
Baudrate 2400, 4800, 9600, 19200
time
date
weekday
ON, OFF – automatic image rotation when camera is tilted above the lowest point
ON, OFF – matching movement speed to zoom level
NONE, PRE01... PRE80, SCAN1... 4, TOUR1... 4, PAT1... 4, AUTO
start activity:
NONE = none
PRE01... 80 = go to the position saved in the preset selected
SCAN1... 4 = perform a scan movement saved
TOUR1... 4 = perform a tour movement saved
PAT1... 4 = perform a pattern movement saved
AUTO = resume the activity most recently performed
time of inactivity after which an activity (IDLE ACTION) is automatically started
IDLE TIME
1 ... 240 (min.); 0 = no automatic activity
IDLE ACITON
NONE, PRE01...80, SCAN1...4, TOUR1...4, PAT1...4
delete all presets saved (submenu FUNCTION)
delete all pattern movements recorded (submenu FUNCTION)
delete all programmed tours (submenu FUNCTION)
reset the submenus SYSTEM and FUNCTION to their factory setting
restart the camera
video signal format AHD/1080, TVI/1080, CVI/1080, CVBS
⚠ with CVI/1080 and CVBS, only control via RS-485 is supported
PAL, NTSC; ⚠ do not change (may result in image loss)!
ON, OFF – insertion of the current zoom factor
AUTO, MANU, KEYAUTO – autofocus mode: automatic, manual, KEYAUTO = after
manual adjustment, the camera will be switched to the autofocus mode when a
movement has been performed
1...7, 8 = zoom speed
basic setting for the lens
AHD – display of the video signal format
reset the settings of this submenu
call up another submenu
here: return to the main menu
☞
CONFIRM
☞
CONFIRM
☞
☞
SYSTEM ➧ VIDEO OUTPUT
menu table b
☞
POWER UP RUN