Monacor AXC-3557PTZ Mode D'emploi page 21

a Menu line
Selection/ Submenu
FUNCTION – Saving options
PRESET – The presets are saved by means of the corresponding commands at the control panel.
SCAN NUMBER
SCAN SPEED
SET LEFT LIMIT
SCAN –
SET RIGHT LIMIT
CLEAR SCAN
RUN SCAN
PATTERN NUMBER
RECORD PATTERN
PATTERNS –
RUN PATTERN
CLEAR PATTERN
TOUR NUMBER
TOUR –
EDIT TOUR
INFRARED LED – Infrared illumination
SENSITIVITY
MANUAL DELAY
IR ON/OFF
IR ON/OFF –
ON TIME
OFF TIME
LUMINANCE
LUMINANCE –
TELE LED
WIDE LED
EXIT Exit menu
Options in bold = factory settings
Setting; function
1...4 – select number of the scan to be set
1... 20 ... 63 = scan speed
define left-hand limit of the scan (save with „IRIS +", reject with „IRIS −")
define right-hand limit of the scan (save with „IRIS +", reject with „IRIS −")
delete scan settings
start scan
1...4 – select number of the pattern to be set
record the pattern (terminate recording with „IRIS +")
run pattern
delete pattern
1...4 – select number of the tour to be set
PO-S-TM PO-S-TM define program steps of the tour:
01-8-04 02-8-04 preset number (0...80) – speed (0...8) – dwell time (0...60 s)
⋮ ⋮
15 ... 73 ... 99 = sensitivity (threshold for switch-on/switch-off)
0 ... 250 min = illumination time after manual switch-on
0 = no automatic switch-off
AUTO = automatic according to lighting conditions; dependent on SENSITIVITY
MANUAL = manual switch-on/switch-off (when preset 62/63 is called up)
TIME = time-controlled switch-on/switch-off
switch-on time (when IR ON/OFF = TIME)
setting of the current time
switch-off time (when IR ON/OFF = TIME)
setting of the current time
AUTO = automatic balance between close-range and far-range illumination, depending
GROUP = automatic, identical setting of all LEDs
MANUAL = manual luminance settings
0 ... 80 ... 100 = luminance for far-range illumination (when LUMINANCE = MANUAL)
0 ... 80 ... 100 = luminance for close-range illumination (when LUMINANCE = MANUAL)
☞
SYSTEM ➧ CLOCK SETTING
☞
SYSTEM ➧ CLOCK SETTING
on the distance setting of the camera
21