Weka Design 213 B+ Instructions De Montage, D'utilisation Et D'entretien page 10

Wood protection
The product consists of the natural product wood. This makes that it must be regularly treated with sufficient
wood preservation measures. For professional wood preservation treatment, contact a wood preservative
expert.
Wood preservation measures are the responsibility of the customer. No guarantee can be given if the wood
is not properly preserved. Please also read the provisions relating to this in our guarantee statements.
If you arrange to have the assembly carried out by a weka assembly team, the required applications of the
wood protection agent must be completed prior to assembly beginning.
This must be considered before installation!
Preparation of the substrate
Once the ground has been successfully levelled, the height and horizontal position of the foundations are to
be marked out.
A prerequisite for assembly is an expertly laid, level and square foundation. We recommend a raft
foundation. A foundation plan can be obtained from your specialist dealer.
In order to avoid rising damp, we recommend that a barrier layer be laid between the foundation and the
floor beams using the packaging film, roofing paper or similar. Roofing paper for a barrier layer is not
included in the scope of this delivery.
In order to avoid wind damage, anchor the floor beams of the cabin to the foundation and fix the vertical
studs from the extension to the foundation. Concrete anchors or steel angles and heavy-duty dowels
available from specialist dealers are suitable for this. The anchors are not included in the scope of this
delivery.
This must be considered during installation!
At least two people are required to assemble the WEKA product.
All screw connections are to be pre-drilled in order to avoid damaging the wood parts. The following symbols
in the instructions will indicate when this is necessary:
In order to check the right angles, measure the diagonals and make any necessary corrections until you
have the same values.
When laying the roof boarding, care should be taken to ensure that the roof boards are not pressed tightly
into each other. Subsequent swelling of the wood as a result of moisture is unavoidable.
With products such as bitumen roof covering, the roofing paper included serves as preliminary protection
against weathering. To guarantee lasting protection, we recommend that you also apply a further layer of
roof paper with bitumen cold bonding agent (not included in delivery) or cover the roof with bitumen roof
shingles. This provides a good basis for a long life and resistance to the influences of the weather. If this is
not done, your weka product may incur damage.
If you have decided to cover your house with bitumen shingles, we recommend that they are laid
directly on the roof boards.
The film on the bitumen strips is to be removed before laying!
Tools
You should have the following tools to hand before beginning assembly:
Tape measure Drill Electric screwdriver Hammer Pencil Burring iron Rubber mallet
 Copyright weka-Holzbau GmbH, Neubrandenburg
10
Techn. Änderungen vorbehalten!