PROEL WEDGE Série Notice D'utilisation page 16

6. PRESET MONITOR/FOH selector
This switch allows the selection between two equalisation settings, suited to two different uses.
MONITOR
Suited for stage monitoring sound reinforcement for an improved feedback rejection.
FOH
This preset has been designed for typical sound reinforcement applications with the speaker mounted on floor
stand.
7. POWER switch
Speaker is "ON" when the switch is in the "I" position.
NOTE: When you shut down your equipment, turn off the speaker first. When powering up, turn on the speaker last.
8. ON indicator
GREEN LED: when lighted indicates that the amplifier has been turned on and AC power is available.
9. LINE VOLTAGE selector
This switch sets the AC voltage line of your country (usually it is set by factory and isn't necessary to change it). The 115V
setting is for mains line in the range of 105-120V~ and 230V setting is for mains line in the range of 210-240V~.
WARNING: an incorrect setting of AC LINE VOLTAGE could damage seriously the internal electronics!
10. AC~ socket
Here's where you plug in your speaker's mains supply cord. You should always use the mains cord supplied with the
speaker. Be sure your speaker is turned off before you plug in the cord.
11. FUSE holder
Here is where the mains protection fuse is placed.
REPLACE THE PROTECTION FUSE ONLY WITH SAME TYPE AS SHOWN ON THE PRODUCT.
IF AFTER THE SUBSTITUTION, THE FUSE INTERRUPTS AGAIN THE APPARATUS WORKING, DO NOT TRY AGAIN
THEN CONTACT THE PROEL SERVICE CENTER.
16