Maintenance - Greencut GTC190X Manuel D'utilisation

ADJUSTMENTS AND ADVICE
ATTENTION: Turn off the engine before making adjustments. Use caution when using the recoil
lever.
CARVING TIPS
The key to good ploughing is to do a superficial job on the first pass, and then increase the depth.
• Ploughing in depth will depend on soil conditions.
• When starting to work on very hard or compact soil, place the retaining pin in the highest hole. This will allow you
to work less deeply. With the depth regulator in this position, make several passes over the area to be cultivated.
Then make successive layers.
• If the handlebar jumps or moves uncontrollably, lower the depth adjuster by placing the teeth in a higher hole.
This will allow you to work normally.
• If there are weeds or vegetation obstructing the passage, change the position of the handlebars so that you can
pass.
CULTIVATION TIPS
If you want to use the hoe to cultivate:
• Sow different rows of plants leaving between 15 and 20 cm distance between each row.
• Place the depth adjuster lever with the retaining teeth in one of the highest holes. This will allow the correct
cultivation through the weeds and you will be able to divide the soil of the area.

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
MAINTENANCE
Review
Belt tension
Change
Check level
Engine oil
Change
Review
Air filter Clean
Replace
Review
Transmission
rudder
Replace
Tyre pressure Review
Shaft teeth Clean
Semi Wheel
Lubricate
Shaf
EVERY
EACH USE MONTH OR
24H USE
X
X
X
X
X
X
X
EVERY 3 EVERY 6
MONTHS MONTHS
OR 50H OR 100H
USE USE
X
X
X
X
X
61
EN
EVERY
YEAR OR
300H USE
X