Zibro D 4 Manuel D'utilisation page 22

A
SAFETY
•
•
•
•
•
•
Fig. 1
WARNING
-
-
-
B
CONNECTION
1
2
C
CONTROLS
1
Fig. 2
2
Fig. 3
4
22
After having finished using the Zibro Dehumidifier, the user should switch
the unit off by pressing the button (1) to 'off' position.
Avoid using the AC/DC switching mode power supply in wet or damp place,
and position it in areas where the air ventilation is good.
Keep the front inlet grill and the top outlet free from air blocking materials
such as clothing, plastic bag or papers.
If the unit has been properly connected and no power is flowing, have the
AC/DC switching mode power supply checked by a qualified electrician to
ensure that the fuses inside the switching mode power supply are not faulty.
Always keep the unit at an up-right position to avoid water leakage.
The thumb should be placed at the top centre of the unit while lifting by the
lift-slot (7), to avoid tilting. At the same time, the other hand should be
holding the base to secure the unit. [as Fig. 1]
To avoid electric shock. Do not open. There are no user serviceable parts
inside.
Any repair work must be done by qualified technician appointed by our
distributors.
Specifications are subject to change for improvement without prior notice.
After removing the packaging materials, there should be 2 items:
a. Zibro Dehumidifier
b. AC/DC switching mode power supply (220/240 V / 13V)
Plug the DC power jack (11) of the switching mode power supply to the DC
power socket (8), then connect the AC plug (12) of the switching mode power
supply to the appropriate main socket.
Press the button (1) to position
LED will be turned on. Listen and feel for the air blowing from dry air outlet.
[as Fig.2]
To switch off the unit, press button (1) to 'off' position, the Zibro will be
turned off. [as Fig.3]
, the Zibro will begin to operate. The green