Still Mode; Switching Each Input Mode; Switching Audio Mode - Magnavox 37MD350B Manuel De L'utilisateur

 Still Mode
You can pause the image shown on the TV screen.
Press [FREEZE] to pause the image shown on the TV
screen.
• The sound output will not be paused.
• If no signal is detected or protected signal is received
during still mode, the image remains paused and the
sound output will be muted.
• The still function will be released after 5 minutes.
To cancel still mode, press any button except
[y y (power)].
 Switching Each Input Mode
g
You can easily switch with the remote control between TV (ATSC or NTSC)
and external devices when they are connected to the unit.
Press [SOURCE] or [CH
the input modes.
37MD350B
Source
TV
Video
Component
HDMI1
HDMI2
HDMI3
DTV/TV channel
Component
HDMI1
HDMI2
HDMI3
-
• Pressing [CH ] reverses the direction of the input
modes.
FREEZE
p
+
] repeatedly to cycle through
32MD350B
Source
TV
Video
Component
HDMI1
HDMI2
DTV/TV channel
Video Video
Component
HDMI1
(or PC input) (or PC input)
HDMI2
 Switching Audio Mode
g
This section describes how to switch the audio in the analog mode and how
to switch the audio language in the digital mode.
TV
Press [SAP/AUDIO] to display the currently selected
audio mode. While receiving an MTS broadcast,
press repeatedly to cycle through the available audio
channel.
When all audio are available
SAP / STEREO
SAP /
When stereo and monaural audio are available
MONO / STEREO
When SAP and monaural audio are available
SAP / MONO
When only monaural audio is available
(cannot be switched)
STEREO : Outputs stereo-audio
SAP : Outputs second audio program
MONO : Outputs mono-audio
DTV
1
Press [SAP/AUDIO] to display the currently selected
language and the number of available languages.
2
Press [SAP/AUDIO] repeatedly to cycle through the
available audio languages.
• Available languages differ depending on the
broadcast. "Other" is displayed when the audio
language cannot be acquired, or the acquired
languages are other than English, Spanish or French.
Note:
• [SAP/AUDIO] does not control external audio devices.
]
• The information display will automatically disappear in a
few seconds.
11
SAP / STEREO
SAP / MONO
STEREO
MONO / STEREO
SAP / MONO
MONO
11.1
English 1/3
19 19
EN