Preventive And Corrective Maintenance; Cleaning The Stapler; Removing Jammed Staples - Signode JOSEF KIHLBERG JK35-590 Mode D'emploi

Josef Kihlberg JK35-590
7
Before all maintenance tasks on the
stapler always first disconnect it from
the air supply.

7.1 CLEANING THE STAPLER

This stapler does not require special servicing. It only
needs regular cleaning with a non-aggressive (non-
corrosive) cleaner agent. Do not remove any parts for
cleaning purposes!
Check the proper functioning of all safety
devices daily. Make especially sure that:
– the trigger works smoothly, the door stays in place
and the magazine lid does not open itself.
– all screws and nuts are securely tightened.
– the stapler is regularly lubricated (refer to chapter
5.2).

7.2 REMOVING JAMMED STAPLES

To remove a staple which has become jammed:
– Unscrew the two front screws two turns (Fig. 6/1).
– Remove the door from the screws (Fig. 7/1).
– Clean the nozzle from the defective staple.
– Assemble in the oposit way.
8

PREVENTIVE AND CORRECTIVE MAINTENANCE

1
Fig. 6
1
Fig. 7
05.20