Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FIRST TIME USE
•
Wait at least two hours, after the installation, before connecting the appliance to the power supply.
Connect the appliance to the power supply and turn the thermostat knob to switch on the appliance.
After turning the appliance on, you must wait for 4-6 hours for the correct storage temperature to be
reached for a normally filled appliance.
•
Your fridge may have a smell when it is operated for the first time. This is normal and the smell will
fade away when your fridge starts to cool.
USAGE INFORMATION
Thermostat setting
•
Larders (coolers) have not any freezer compartment but can cool below 5°C.
•
Thermostat automatically regulates the inside temperature of the refrigerator compartment.
By rotating the knob from position 1. to 5., colder temperatures
can be obtained.
•
« • » position shows thermostat is closed and no cooling is
available.
•
For short-term storage of food in the freezer/refrigerator
compartment, you can set the knob between minimum and
medium position.(1-3)
•
For long-term storage of food, you can set knob to medium position.(3-4)
Temperature Settings Warnings
•
Larders (coolers) have not any freezer compartment but can cool up to 4 - 6 °C.
•
The ambient temperature, temperature of the freshly stored food and how often the door is opened
affects the temperature in the fridge. If required, change the temperature setting
•
It is not recommended that you operate your fridge in environments colder than 10°C in terms of its
efficiency.
•
When setting the thermostat, take into consideration how often the appliance door is opened and
closed, how much food is stored in the refrigerator, and the environment in which the refrigerator is
located.
•
When the appliance is first switched on, allow it to run for 24 hours in order to reach large quantity of
food inside. operating temperature. During this time, do not open the door and do not keep a large
quantity of food inside.
•
Unplug your appliance during a power cut to prevent damage to the compressor. Once power is
restored, delay plugging in your appliance for 5 to 10 minutes. This will help prevent damage to the
appliance's components.
•
Your appliance is designed to operate in the ambient
temperature ranges stated in the standards, according
to the climate class stated in the information label. It is
not recommended that your fridge is operated in the
environments which are outside of the stated temperature
ranges. This will reduce the cooling efficiency of the
appliance.
•
This appliance is designed for use at an ambient
temperature within the 10°C - 43°C range.
Climatic Class
EN - 31
Amb. T. (°C)
SN:
From 10 to 32 °C
ST:
From 16 to 38 °C;
N:
From 16 to 32 °C
T:
From 16 to 43 °C
Publicité
Table des Matières
