Location Requirements; Electrical Requirements; Explosion Hazard; Recommended Grounding Method - Gladiator Garageworks CHILLERATOR GARF19XXVK Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Location Requirements

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
To ensure proper ventilation for your refrigerator, allow for ¹⁄₂"
(1.25 cm) space on each side and at the top. When installing your
refrigerator next to a fixed wall, leave 2" (5.08 cm) minimum on the
hinge side (some models require more) to allow for the door to swing
open.
IMPORTANT:
Do not install the refrigerator near an oven, radiator, or other heat
source where the temperature will rise above 115°F (43°C), nor in
a location where the temperature will fall below 0°F (-17°C).
The warmer the outside temperature, the longer it will take the
refrigerator to cool to the set point temperature when food is
added.
1
/
" (1.25 cm)
2
2" (5.08 cm)

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator into its final location, it is important
to make sure you have the proper electrical connection.

Recommended Grounding Method

A 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, grounded electrical
supply is required. It is recommended that a separate circuit serving
only your refrigerator be provided. Use an outlet that cannot be
turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn the control (Thermostat, Refrigerator or
Freezer Control depending on the model) to OFF and then
disconnect the refrigerator from the electrical source. When you are
finished, reconnect the refrigerator to the electrical source and reset
the control (Thermostat, Refrigerator or Freezer Control depending
on the model) to the desired setting. See "Using the Controls."
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Chillerator

Table des Matières