SOLAC CP7320 Mode D'emploi page 15

CP 7320.book Page 15 Wednesday, December 19, 2007 11:51 AM
5 After charging, unplug the charger from the mains and then unplug the
cable from the connector (8). The appliance is ready to be used.

A 12-hour charge provides approximately 50 minutes of operation.

When charging, the charger heats up slightly. This is normal, unless it
becomes very hot.
Recommendations for extending the life of the batteries

The hair clipper has an electronic circuit for charging the batteries
correctly, which extends their useful life. However, it is advisable to
follow the advice given below.
• Do not leave the charger connected for long periods of time. Disconnect
it when it has finished recharging.
• Do not use the hair clipper with the cord plugged in when the batteries
are completely charged.
• Do not store or recharge the appliance close to radiators or other
sources of heat, or expose it to direct sunlight.
• Do not recharge the appliance in dirty or wet places, and room
temperature should be between 0º C and 40º C.
• Every few months, allow the batteries to drain completely and then
recharge them. To discharge them, turn the appliance on without the
cord until it stops running, then put the switch (2) in the "0" position. Then
recharge the batteries as explained above.
4 Use

This appliance is designed to cut human hair. Do not use it for other
purposes.

If you use the hair clipper in the shower, do so without the charger. Do
not submerge either the clipper or the charger under water.
Operation with the cord or with the batteries
• You can use the hair clipper with the batteries or with the charger. If the
batteries are discharged completely, leave the appliance plugged in for
5 minutes with the switch in the "0" position before using it. It is not
advisable to use the appliance with the charger if the batteries are
completely discharged.
Use
en
15