SOLAC CP7320 Mode D'emploi page 13

CP 7320.book Page 13 Wednesday, December 19, 2007 11:51 AM
• Before plugging in the appliance to the mains, check that the indicated
voltage matches the voltage in your home.
• Always unplug the appliance after use and before removing or installing
parts and before performing any maintenance or cleaning task. Also
unplug it in the event of a power outage. When you plug in or unplug the
appliance, it must be turned off.
• Do not pull on the power cord or hang the appliance by the cord. Always
unplug the appliance by pulling on the plug, never the cord.
• Never leave the appliance exposed to the elements.
g
The appliance complies with internationally approved IEC safety
standards and can be used safely in the bath or shower with the
charger (10) unplugged.
• Avoid splashing water on the charger or the power cord.
• Use only the supplied charger to charge the appliance.
• Never submerge the charger or the hair clipper in water or any other
liquid, or place them in a dishwasher. Do not allow the charger to come
into contact with water during cleaning.
• Do not touch the charger with wet hands when it is plugged in.
• Never leave the charger working on a wet surface or cloth.
• If you use the appliance without any guide combs, be careful not to injure
your skin.
• If the blade or the guide combs show signs of breakage or damage, stop
using the appliance and repair them before using it again.
• The blades must be clean and have no traces of hair to work properly.
Therefore, use the attached brush (17) to clean them before and after
use.
• Electrodomésticos SOLAC S.A. hereby disclaims all liability for injuries
or damage that could be caused to persons, animals or property due to
the failure to heed with these warnings.
2 Description
Main parts
1 Main body of the appliance
2 Speed selector switch
3 Adjustable handle
4 Handle fastening button
5 Adjustable cutting head
Description
en
13