FLAEM RF6 Basic 2 Mode D'emploi page 13

TROUBLESHOOTING
Switch off the device before any procedure and unplug the power cable from the socket.
PROBLEM CAUSE
The power cable has not been
The device does not
correctly inserted into the socket of
work
the device or the power socket
The medication has not been
inserted in the nebulizer
The nebulizer has not been
properly fitted.
The device does not
nebulize or
The nebulizer nozzle is clogged
nebulizes
insufficiently.
The air pipe is not correctly con-
nected to the device
The air pipe is bent, damaged or
twisted
The air filter is dirty
The apparatus is The Filter is not correctly
noisier than usual inserted in its housing
If after verifying the above mentioned conditions the device should not operate properly, contact your trusted retailer
or the nearest authorized FLAEM service center.
SYMBOLS
EC Marking medical ref. Dir 93/42 EEC and subse-
quent updates
Class II device
Attention: check the instructions for use
"OFF" for part of Equipment
"ON" for part of equipment
In compliance with: European Standard EN 10993-
1 ''Biological Evaluation of medical devices'' and
European Directive 93/42/EEC "Medical Devices. "
Phthalate-free. In compliance with: Reg. (EC) no.
1907/2006
Minimum and maximum room temperature
Minimum and maximum atmospheric pressure
SOLUTION
Correctly insert the power cable in sockets.
Pour the right amount of medication in the nebulizer
Disassemble the nebulizer and reassemble it correctly as
shown in the connection diagram on the cover.
Disassemble the nebulizer, remove the nozzle and
perform cleaning operations.
Failure to remove medication deposits from the nebulizer
affects its efficiency and operation.
Strictly comply with the instructions
contained in the "CLEANING, SANITISATION,
DISINFECTION" chapter
Ensure the device's accessories are properly connected to
the air intake (see connection diagram on the cover).
Unwind the pipe and ensure it is not crushed or
punctured. If necessary replace it.
Replace the filter
Fully and properly insert the Filter in its housing
TÜV approval
Device serial number
Manufacturer
Type BF applied part
Alternating current
Keep dry
Risk: electrocution.
Consequence: Death.
Using the device while taking a bath or shower is
prohibited
Minimum and maximum air moisture
11