Haier BF4D620B Manuel D'utilisation page 92

l
Pressing the "PROGR." button you can
select the parameters to be adjusted in
succession (SOFTENER → BUZZER →
MEMO FUNCTION).
l
Parameter adjustment is performed by
pressing the "OPEN DOOR/EXPRESS"
and "EXTRA DRY" buttons.
l
To adjust the SOFTENER see the specific
Chapter of the manual).
l
To adjust the BUZZER see the specific
paragraph).
l
To adjust the MEMO FUNCTION see the
specific paragraph).
"AUTOMATIC" programmes
(only on some models)
Models with Smart Loading Sensor
The "Auto Daily Wash" programme, thanks
to an algorithm that analyses the degree of
dirtiness of the dishes in real time,
automatically sets the ideal temperature
and washing time , optimising water and
electricity consumption
Models with dirt sensor
(Only on some models).
The dishwasher is equipped with a dirt
sensor, capable of analysing water murkiness
during all "AUTOMATIC"
phases (see programme legend). Thanks
to this device, the wash cycle parameters
are automatically adapted to the real
quantity of dirt on dishes. This is because
water murkiness is linked to the quantity of
dirt on dishes. Thus, excellent washing
results are guaranteed while optimising
water and energy consumption.
"IMPULSE" programmes
(only on some models)
The "IMPULSE" programmes use an
impulse washing technology, which reduces
consumption and noise, and improves
performance.
The "intermittent" working of the
washing
considered a malfunction; it is a
characteristic of impulse washing,
and therefore should be considered a
normal feature of the programme.
ADDISH
dishes after the programme has
started)
When the programme starts, you should
only open the door and add more dishes
when the ADDISH
switched on. The appliance will stop
automatically and the time remaining to the
end of the cycle will flash on the display. Close
the door, without pressing any buttons.
Open the door slowly and carefully, to
avoid getting wet with splashes of
washing water.
Adding
indicator light has switched off is
strongly discouraged as this could
affect the wash performance.
programme
If you open the door during the drying
cycle, an intermittent audio signal
advises you that the drying cycle has
not yet finished.
Programme interruption
Opening the door when a programme is
running is not recommended especially
during the main wash and final hot rinse
phases. However, if the door is opened
while a programme is running (for example,
to
automatically. Close the door, without
pressing any buttons. The cycle will start
from where it left off.
92
pump is
(possibility of adding
dishes after
WARNING
add dishes) the
NOT to be
indicator light is
the ADDISH
machine stops