Grill Plates; Waffl E Plates - gourmetmaxx SW-072B Mode D'emploi

Grill plates

With these plates, you can use the device like an electric tabletop grill. The plates are suitable
for preparing all kinds of meat, fi sh and vegetables.
1. Insert the grill plates in the device as described in the chapter "Inserting and changing the
plates".
2. Connect the device to a properly installed, easily accessible socket. The red power LED will
illuminate as soon as the device has been connected to a socket.
3. The device must pre-heat now. Always keep the device closed during this time. The pre-
heating process takes about 3–5 minutes and has ended when the green power LED
illuminates.
4. When the green power LED illuminates and the pre-heating process has ended, release the
latch and open the device.
5. Now place your food (e. g. patties for hamburgers, chicken fi llets or vegetables) on the
bottom grill plate.
• You can prepare your meals with the grill open or closed. However, please keep
in mind that the cooking time is longer when the grill is open as more heat is lost
when preparing meals this way.
• When you close the grill, make sure that the latch has correctly locked into place
to keep the grill closed while grilling.
• Only use wooden or plastic kitchen utensils to fl ip or remove food to prevent
damage to the coating.
6. The green power LED may alternately turn off and back on while grilling. If the green power
LED illuminates, this indicates that the device is reheating to maintain a constant temperature.
7. If you do not plan to prepare any other foods, pull the mains plug out of the socket and
let the device cool off completely before you remove and clean the plates and store them
together with the device.
Waffl e plates
You can prepare delicious waffl es with these plates.
1. Insert the waffl e plates in the device as described in the chapter "Inserting and changing the
plates".
2. Connect the device to a properly installed, easily accessible socket. The red power LED will
illuminate as soon as the device has been connected to a socket.
3. The device must pre-heat now. Always keep the device closed during this time. The pre-
heating process takes about 3–5 minutes and has ended when the green power LED
illuminates.
4. When the green power LED illuminates and the pre-heating process has ended, release the
latch and open the device.
5. Now add the waffl e batter to the bottom waffl e plate. Do not overdo it so that the batter is
not pressed out on the sides when you close the device.
6. Close the device and lock it with the latch so that it stays closed during the baking process.
Please note that the green power LED may alternately turn off and back on during the baking
process. If the green power LED illuminates, this indicates that the device is reheating to
maintain a constant temperature.
28