Waeco Mobitherm MWH-020/N Instructions De Montage Et De Service page 32

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
MWH-20-N_60-N_EB_10s.book Seite 32 Montag, 5. Februar 2007 5:57 17
Connecting the water heater
Note the following instructions when making the electrical connection:
The wire diameter may not be less than 2.5 mm².
Only use multiple-core cables (not single-core cables), because
vibrations on the boat can damage them.
Protect all electrical connections and cables against moisture and damp.
Do not lay the cable along the keelson.
Fasten the cable at suitable intervals using cable clips, or lay it in a cable
duct.
Protect the cable from contact with moving parts that might damage it.
Caution
e
Always take out the power plug before taking off the plastic cover.
➤ Make sure the AC voltage matches the information on the heating
cartridge of the water heater (on the type plate under the plastic cover).
➤ Make sure a residual current circuit breaker is installed in the on-board
electrical system.
➤ Fit a switch (220 V/10 A) somewhere accessible so that the power for the
water heater can be easily switched on and off.
➤ Protect the connection using with a fuse (220 V/10 A).
32
Mobitherm

Publicité

Table des Matières
loading

Table des Matières