Waeco Mobitherm MWH-020/N Instructions De Montage Et De Service page 28

MWH-20-N_60-N_EB_10s.book Seite 28 Montag, 5. Februar 2007 5:57 17
Mounting the water heater
Install the water heater in a well-ventilated place, in order to avoid con-
densation.
Fasten the water heater securely.
Note: the overall weight of the water heater is its own weight plus that of
the water in it.
During installation, note the information on the type plate.
The type plate is on the plastic cover on the front.
This is how to install the water heater:
➤ Install the water heater in its intended position:
– fig. 1, page 3: lying on the floor
– fig. 2, page 3: additional fastenings are required for mounting on
bulkheads
– fig. 3, page 4: upright on the bulkhead
– fig. 4 A, page 4: diagonally on the floor
– fig. 4 B, page 4: diagonally on the bulkhead
➤ Check whether the side marked "TOP" is at the top.
Caution!
a
Fasten the water heater on all five fastening points. Use five M10
bolts and washers with a diameter of 30 mm, with a tightening
torque of 6 – 10 Nm. The water heater can be damaged if the
washers are too small or the bolts too tight.
➤ Bolt on the water heater using five M10 bolts and 30 mm washers.
28
Mobitherm