1.
Thank you for purchasing this handcrafted Start Booster manufactured in
Switzerland. This device was designed for professional use only. Our focus is to
provide quality Start Boosters for professionals who will depend on them to get
the job done.
Make sure the user of this Start Booster has read and understood this user manual
before using the device. It contains important safety instructions.
Please also make sure to recharge your Start Booster completely before every jump
start attempt. Make sure you only use the supplied charger.
Depending on the type of jump starter, please refer to the appropriate section of this
manual for specific precautions. We have developed various technologies to jump
start vehicles and each one has its own specifications.
If you have any questions after reading this manual, please do not hesitate to contact
us or your distributor directly for more information.
2. SAFETY PRECAUTIONS
This device has been designed for trained professionals and according to the codes of
practice valid at that time. It is safe to operate, but please make sure to read and un-
derstand this user manual beforehand. It can be dangerous if it is used by non-pro-
fessionally trained personnel or in an incorrect way. The manufacturer cannot be
held responsible for the incorrect use of this device. Please follow these steps for
maximum safety:
- Always wear safety equipment: Goggles, gloves, ear protection and
appropriate attire.
- Only use accessories or attachments approved by the manufacturer.
- Always keep this manual close when using the device.
- Modifications or alterations to this device are forbidden.
- Repairs and service can only be performed by an official authorized center.
- Only use the supplied automatic or smart charger.
- Damaged chargers or devices must be immediately fixed or replaced.
- Always use this device in a well-ventilated area. Never use in potentially
explosive areas or near flammable materiels.
- Never leave your Start Booster discharged. Always make sure it is fully
charged, otherwise it could void the warranty.
- Avoid short circuits and never have the clamps touch each other, or any metal
part at the same time.
- Never submerge in water, burn or throw away in domestic waste.
- Safety equipment, such as fire extinguisher or water to rinse eyes, should al-
ways be nearby. Also make sure someone else is nearby in case of emergency.
02
GENERAL INFORMATION