Velleman WIFIR3 Mode D'emploi page 5

Note : Plug
You can change the repeater's plug orientation so the repeater fits
into any space.
Refer to the illustrations on page 2 of this manual.
• Gently press the button next to the plug [A] and pull the plug to
detach it.
• Place the plug back in the socket in the desired orientation and
turn it until it snaps into place.
Note: Wireless repeater or access point
You can set up the repeater as a wireless repeater or as a wireless
access point.
Wireless repeater
For wireless repeater mode, you
need a WIFI AP/Router internet
access.
Wireless access point
To use the device as a wireless
access point mode, you need
broadband router internet access.
Connect the repeater to the
router/switch with the included
RJ-45 network cable.
7. Setup
During setup, you will:
• connect your router to the repeater
• connect the repeater to your computer
You can connect your router to the repeater:
• Manually (see section below)
• Using WPS (see section 9)
V. 01 – 22/08/2013
WIFIR3
5 ©Velleman nv