Wash Cycle Table; Energy Saving Tips; How To Keep Your Dishwasher In Shape - Haier DW12-CBE6 IS Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Wash Cycle Table

Cycle

Selection

Information

Very dirty dishes,

pots and pans. (Not

to be used with deli-

Heavy Duty

cate items)

Normal dirty dishes,

pots and pans. Stan-

Normal Wash

dard daily cycle.

Normal dirty dishes,

pots and pans without

dried on residue.

Light Wash

(IEC-EN50242)

Economic, fast cycle to

be used for items which

are sensitive to higher.

Run immediately after

Glassware

dishes are used.

Economic, fast cycle to

be used to on not very

dirty dishes right after

they are used. No dry-

Rapid Wash

ing cycle.

Pre-wash of dishes,

pots and pans while

waiting for the load to

be completed after the

Soak

subsequent meal.

The cycle of heat wash-

ing and dry tableware.

Heat wash

Description of Cycle

Detergent

Rinse Aid

Pre-wash with hot water.

Extended wash at 70 .

30g

Rinses with cold water.

Rinse with hot water.

Drying.

Prewash use cold water.

Extended wash at 55 .

30g

Rinse with cold water.

Rinse with hot water.

Drying.

Pre-wash with cold water.

Extended wash at 50 .

5g+25g

Rinse with cold water.

Rinse with hot water.

Drying.

Wash at 60 .

Rinse with warm water.

15g

Hot rinse.

Drying.

Short wash at 40 .

15g

Cold rinse.

Short cold wash to prevent

food residue from drying on

the dishes .

Heat washing.

.7.

Energy Saving Tips

-It is important to try and run the dishwasher when it is fully

loaded in order to save on energy. In order to prevent odors

from forming and food from caking onto the dishes, you can run

the soak cycle.

-Choose the right wash cycle: the choice of cycle depends on

the type of dishware, cookware and utensils being washed and

how dirty they are.

How to keep Your Dishwasher in Shape

After Every Wash

After every wash, turn off the water supply to the appliance and

leave the door slightly ajar so that moisture and odors are not

trapped inside.

Remove the plug

Before cleaning or performing maintenance, always remove the

plug from the socket. Do not run risks.

No solvents or Abrasive Cleaning Products

To clean the exterior and rubber parts of the dishwasher, do not

use solvents or abrasive cleaning products. Rather, use only a

cloth and warm soapy water.

(5)

To remove spots or stains from the surface of the interior, use a

cloth dampened with water and a little white vinegar, or cleaning

product made specifically for dishwashers.

Cleaning and Special Maintenance

Filter Assembly

For best performance and results, the filter assembly must be

cleaned.

The filter efficiently removes food particles from the wash water,

allowing it to be recirculated during the cycle. For this reason, it

is a good idea to remove the larger food particles trapped in the

filter after each wash cycle by rinsing the "A" semi-circular filter

and cup under running water. To remove the filter assembly,

pull on the cup handle in an upward direction. The entire filter

assembly (made up of the "A" semicircular filter and the "B" fine

filter) should be cleaned at least once a month. To clean the

filter and the fine filter, use a cleaning brush. Then, reassemble

the filter parts as shown in the figures below and inset the entire

assembly in the dishwasher, positioning in its seat and pressing

downward.

The dishwasher must never be used without the filters. Improper

replacement of the filters may reduce performance of the appli-

ance and damage dishes and utensils.

-Use the right amount of detergent: if you use too much detergent,

the result will not be cleaner dishes, but, rather, a greater nega-

tive impact on the environment.

-There is no advantage in rinsing dishes, cookware and utensils

before placing them in the dishwasher.

When You Go on Holiday

When you go on holiday, it is recommended that you run a wash

cycle with the dishwasher empty and then remove the plug from

the socket, turn off the water supply and leave the door of the

appliance slightly ajar. This will help the seals last longer and

prevent odors from forming within the appliance.

Moving the Appliance

If the appliance must be moved, try to keep it in a vertical position.

If absolutely necessary, it can be positioned on its back.

Seals

One of the factors that cause odors to form in the dishwasher is

food that remains trapped in the seals. Periodic cleaning with a

damp sponge will prevent this from occurring.

Cleaning the Spray Arms

It may happen that food particles become encrusted on the

sprayer arms and block the hole (see "Close up view [interior]" ,

letters D-F ). Check the sprayer arms periodically and clean them

when needed.

A A A A A

B B B B B

Cleaning the Water Inlet Filter

Periodically clean the water inlet filter located on the outlet of the

water supply tap.

After turning off the water tap, unscrew the end of the water sup-

ply hose, remove the filter and clean it carefully under running

water. Then, return the filter to its place and tighten the water

supply hose back into position.

.8.

Table des Matières

Ce manuel est également adapté pour:

Dw12-cbe6 i

Wash Cycle Table; Energy Saving Tips; How To Keep Your Dishwasher In Shape - Haier DW12-CBE6 IS Mode D'emploi

Les langues disponibles

Wash Cycle Table

Energy Saving Tips

How to keep Your Dishwasher in Shape

Manuels Connexes pour Haier DW12-CBE6 IS

Contenu connexe pour Haier DW12-CBE6 IS

Ce manuel est également adapté pour:

Table des Matières