Max PJRC160 Manuel D'utilisation Et D'entretien page 14

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

INDICATION OF QUICK CHARGER LAMPS
Charger LED lamp
Red lamp blinks.
It blinks every second.
Red lamp lights.
It remains lit.
The green lamp blinks.
It blinks every second.
The green lamp lights up.
It remains lit.
The red lamp lights up.
The orange lamp lights up.
They remain lit.
The orange lamp lights up.
It remains lit.
The orange lamp blinks.
It blinks quickly (0.1 sec
ON and 0.1 sec OFF).
∗ For batteries those are at low temperatures (10°C (50°F) or lower), charging time must be extended
longer.
For the JC928 lithium ion battery charger (CE)
"Power Supply Cord: Use UL Listed and CSA Certified detachable power supply cord, 18 AWG, two
conductors, cord rated VW-1, 105°C, cord external length minimum 1.8m.
One end terminates in a molded-on attachment plug with a 15 A, 125 V (NEMA 1-15P) or 15 A, 250
V (NEMA 2-15P) type configuration.
Other end terminates in a molded-on connector which mates with the Power Appliance Inlet.
If a flexible power supply cord is required, the appropriate cord (see below) must be used.
The SP-2, SPE-2, SV, SVE, or SVT flexible power supply cord can be used."
Buzzer sound
The power cord is plugged
into the receptacle.
Two short beeps (Pi, pi)
The battery pack is mounted.
One short beep (Pi)
The battery has been re-
charged.
A long beep for approx. 2
seconds (Piii...)
Fully recharged.
A long beep for approx. 2
seconds (Piii...)
Not possible to recharge.
Short continuous beeps for
approx. 10 seconds
(Pi, pi, pi, pi,...)
Recharging status
The charger is
The charger power cord is plugged
powered.
into a wall socket.
The battery is be-
Quick recharging continues.
ing recharged.
The battery has been recharged to ap-
The battery has
prox. 90% of its capacity.
been recharged.
If you leave the battery pack on the
charger, recharging will continue.
Battery is "fully" re-
Recharged to 100% capacity.
charged.
The battery is recharged with a low
Protective charging
current to protect the charger and bat-
tery.
If the temperature of the battery pack
is too high: Battery recharging starts
automatically when the temperature
drops below the limit.
Standby
If the temperature of the battery pack
is too low: Place the battery pack in a
room temperature location for a while,
then retry recharging it.
Unable to recharge the battery.
Not possible to re-
The battery pack slot is contaminated,
charge.
or the battery pack has failed.
14

Publicité

Table des Matières
loading

Table des Matières