Output Data; Transmission Behavior - Knick VariTrans P 2900 P2 Série Mode D'emploi

Output data

Output, active
Output, passive
Max. load (current)
Max. load (voltage)
Overload capacity with
externally applied voltage
Displacement
Overload range
Off set adjustment
Residual ripple
Voltage drop when mea-
suring the output current
at test jacks 3.1 and 3.3

Transmission behavior

Gain error
Off set
Linear dynamic range
Signaling of load error
Response time T
Cutoff frequency
*) Time after change of input value until reaching an output value
of 99 % steady state
0/4 ... 20 mA or 0 ... 10 V, resp., or
–20 ... 20 mA or –10 ... 10 V, resp.
4 ... 20 mA
active ≤ 12 V (600 Ω at 20 mA)
passive 12 ... 26
≤ 10 mA (1 kΩ at 10 V)
± 30 V
up to ±150 % as default
Current output: > 22 mA (max. 26 mA)
Voltage output: < 15 V
±5 %
< 10 mV rms
max. 150 mV
Input ≤ 1 V
Input > 1 V
≤ 0.1 % input range (full scale)
–5% to 105% of input span
Red LED on the front
* < 200 ms or < 200 μs, switchable
99
10 Hz or 10 kHz, switchable
Specifi cations
≤ 0.1% meas.val.
≤ 0.2 % meas. val.
49