Setting Up Your Speakers - Insignia NXT 6.1 Guide De L'utilisateur

IS-SP102371.fm Page 3 Friday, July 29, 2005 5:23 PM
IS-SP102371 Speaker System
Front panel
1 LED
1

Setting up your speakers

Connecting the subwoofer
To connect the subwoofer:
1
Use the supplied audio cable to connect the input jack to the PRE-OUT/
SUBWOOFER jack on the audio output device.
2
After everything is correctly connected, plug the AC power cord into the
AC power outlet.
Tip: Refer to the information plate on the rear or bottom of the audio system for
identification and power supply ratings.
Important: Never make or change any connections while the power is on.
Back panel
• Green in active
(on) mode.
• Red in standby
mode (No audio
signal has been
received for fifteen
minutes).
www.insignia-products.com
1 INPUT
Connect to the
Pre-out of an audio
1
output device.
2 Volume +/-
2
Adjust to increase or
decrease the
subwoofer level.
3 AC MAIN
Connect to the power
outlet.
3
3