Maintenance And Service - Enerpac SOH-10-6 Notice D'emploi

DANGER: To avoid personal injury
keep hands and feet away from
cylinder
operation.
WARNING: Stay clear of loads
supported by hydraulics. After the
load has been raised or lowered, it must
always be blocked mechanically.
WARNING:
uncoupled
hydraulic equipment in a coupled
system.
CAUTION: Avoid sharp bends and
kinks in hose which may cause damage.
Also, bends and kinks lead to premature
hose failure.
4.0 OPERATION
IMPORTANT: It is mandatory that the
operator has a full understanding of all
instructions, safety regulations, cautions
and warnings, before starting to operate any of
this high force tool equipment. In case of doubt,
contact Enerpac.
4.1 Before lifting a load
The cylinder must be
securely attached in the
toe lift base. Keep the
contact surface between
the toe lift and the load
clean. The contact surface
must be free of oil and
grease to avoid the load
slipping off.
Before lifting a load make
sure that the contact
surface of the toe lift
completely support the
load to avoid bending of
the toe.
The chains with the lock pins must always be
positioned in the support feet before lifting to
avoid the support feet from accidentally be
moved during lifting.
4.2 Advancing and retracting the jack
For complete operating instructions refer to the
instruction sheet included with each pump.
and workpiece
Never pressurize
couplers. Only
Handpumps
On handpumps with release valves, close relief
during valve and raise and lower the pump handle to
advance the jack. To retract the jack, open the
release valve.
On handpumps with two position valves, shift
valve to advance position and raise and lower
the pump handle to advance. To retract, shift
the valve to the retract position.
IMPORTANT: Open the pump relief valve slowly
use in order to lower the load slowly.
Power pumps
Shift the valve on the pump to the advance
position and run the pump to advance the jack.
To retract the jack, shift the valve to the retract
position.
4.3 Air removal
Advance and retract the jack several times
avoiding pressure build-up. Air removal is
complete when the jack motion is smooth.

5.0 MAINTENANCE AND SERVICE

Maintenance is required when wear or leakage
is noticed. periodically inspect all components
to detect any problem requiring service and
maintenance. Enerpac offers ready-to-use
spare parts kits for repair and/or replacements.
Contact Enerpac.
IMPORTANT: Hydraulic equipment
must only be serviced by a qualified
hydraulic technician. For repair service,
contact the Authorized Enerpac Service
Center in your area.
• Periodically inspect all components to detect
any problem requiring maintenance and
service. Replace damaged parts immediately.
• Do not exceed oil temperature above 60˚C
[140˚F].
• Keep all hydraulic components clean.
• Periodically check the hydraulic system for
loose connections and leaks.
• Change hydraulic oil in your system as
recommended in the pump instruction sheet.
• IMPORTANT: Always keep the guidings of
the lifting plate greased.
2