Bluetooth - Yamaha MusicCast WX-030 Mode D'emploi

TROUBLESHOOTING

Bluetooth

Problem
Cannot make this unit
paired with the connecting
device.
Cannot establish a
Bluetooth connection.
No sound is produced or
the sound is interrupted
during playback.
18
En
Cause
The connecting device does not support
A2DP.
The passkey of the devices, such as a
Bluetooth adaptor, that you want to pair
with this unit is other than "0000."
This unit and the connecting device are
too far apart.
There is a device (microwave oven,
wireless LAN, etc.) that outputs signals in
the 2.4 GHz frequency band nearby.
The unit is in standby mode.
Another Bluetooth device is connected.
This unit is not registered on the connecting
device's Bluetooth connection list.
The unit is in Eco Standby mode.
Another Bluetooth device is connected.
The Bluetooth function of the device is
turned off.
The pairing information has been deleted. Perform pairing again (☞ P.11).
The Bluetooth connection of this unit with
the connecting device is disconnected.
This unit and the connecting device are
too far apart.
There is a device (microwave oven,
wireless LAN, etc.) that outputs signals in
the 2.4 GHz frequency band nearby.
The connecting device's Bluetooth
function is off.
The connecting device is not set to send
Bluetooth audio signals to this unit.
The pairing setting of the connecting
device is not set to this unit.
The connecting device's volume is set to
the minimum.
The connecting device is connected to
more than two Bluetooth devices and this
unit (WX-030) is not selected as a
playback device.
Solution
Perform pairing operations with a device
which supports A2DP.
Use a connecting device with a passkey
"0000."
Move the connecting device closer to this
unit.
Move this unit away from the device that is
emitting radio-frequency signals.
Turn the unit on and perform pairing (☞ P.11).
Terminate current Bluetooth connection, and
perform pairing with the new device.
Perform pairing operations again (☞ P.11).
Turn the unit on, then establish a Bluetooth
connection (☞ P.11).
Terminate current Bluetooth connection, then
establish a Bluetooth connection with that
device again.
Turn on the Bluetooth function of the device.
This unit can be paired with up to 20 devices.
(Depending on the conditions of use, the
maximum number of devices the unit can
connect decreases.). If pairing with the 21st
device is performed, the pairing information
with the oldest connection date will be
deleted.
Delete any pairing history of WX-030 on the
iPhone/iPad/iPod touch, then pair with the
WX-030 again (☞ P.11).
Perform Bluetooth connection operations
again (☞ P.11).
Move the connecting device closer to this
unit.
Move this unit away from the device that is
emitting radio-frequency signals.
Turn on the Bluetooth function of the
connecting device.
Check that the Bluetooth function of the
connecting device is set properly.
Set the pairing setting of the connecting
device to this unit.
Increase the volume level.
Select this unit as a playback device for the
connecting device.