OK. OVC 203 Mode D'emploi page 19

ASSEMBLY
• You can carry the device on the carrying handle (19). Swivel it upwards. Swivel it downwards
before storing.
• Assembly the vacuum cleaner on a non-slip, dry surface in order to avoid injuries.
• Put the adaptor of the suction hose (14) into the suction hose coupling (16) of the vacuum
cleaner. A "clicking" sound must be heard.
• In order to detach it after use, press the hose locking devices from both sides and pull out the
adaptor from the suction hose coupling.
• To use the suction tube, put together both extension tubes (7). Now insert the tube coupling
into the end of the suction tube with synthetic casing. Slightly turn both to ensure firm hold.
• The kombi floor brush (8) can be attached to the lower end of the tube. The kombi floor brush
(6) can also be attached directly to the hose coupling (4).
OPERATION
Before first use read the SAFETY INSTRUCTIONS.
Kombi floor brush
• Adjust the kombi floor brush with the switch Carpets
Carpet the brush border will retract. This setting is intended for carpeted floors.
• If you set the switch to Brush
floors like wooden floors, linoleum, floor tiles.
Wooden floors, linoleum, floor tiles
Carpeted floors
Crevice nozzle
• Crevice nozzle (10) is equipped with a brush attachment which can be swivelled outwards in
the direction of the arrow.
• Crevice nozzle is intended for crevices, corners, cracks, etc.
• Crevice nozzle can be attached to the suction tube or directly to the tube coupling on the
suction hose.
• Suction power control for the air supply (5) on the handle is used to adjust the suction power.
The more the suction power control is opened in the direction of the arrow, the less suction
power the device has.
Switching the device on and off
• Pull out enough power cord (21) from the device. Caution: The power cord must not be pulled
out past the yellow marking. Pulling out up to the red marking could damage the device.
• Connect the power plug with the corresponding socket.
• Press the On / Off switch (18) to switch the device on. In order to later switch the device off,
press the On / Off switch again.
Winding up the cord
• Switch the device off and disconnect the power plug from the socket.
• Carefully press the cord winding button (19). Please note that if you press the button too hard,
the cord can start moving very fast. Danger of injury!
Operation
• Place the kombi floor brush on the floor.
• Switch the vacuum cleaner on as described above and move the kombi floor brush with
horizontal movements forwards and backwards. Do not press on the kombi floor brush.
• When using the crevice nozzle, guide it along crevices, cracks or openings.
IM_OVC202_140625_V02_HR.indb 19
19
the brush border will extend. This setting is intended for even
Brush. If you press the switch
25/6/14 5:37 PM