Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FUNCTIONAL
DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
the battery cartridge is removed before adjust-
ing or checking function on the tool.
Installing or removing battery
cartridge
1
2
► 1. Interlock switch 2. Battery cartridge 3. Red part
4. Button
•
Always switch off the tool before insertion or
removal of the battery cartridge.
•
To remove the battery cartridge, raise the interlock
switch and withdraw it from the tool while sliding
the button on the front of the cartridge. (Note:
Battery cartridge cannot be removed without
raising the interlock switch.)
•
To insert the battery cartridge, align the tongue
on the battery cartridge with the groove in the
housing and slip it into place. Always insert it all
the way until it locks in place with a little click. If
you can see the red part on the upper side of the
button, it is not locked completely. Insert it fully
until the red part cannot be seen. If not, it may
accidentally fall out of the tool, causing injury to
you or someone around you.
•
Lower the interlock switch after insertion of battery
cartridge. Even if the switch trigger is pulled with
the interlock switch raised, the tool does not start.
(Note: The battery cartridge can be inserted even
while the interlock switch is lowered. Once the
battery cartridge is inserted, the interlock switch
will rise automatically.)
•
Do not use force when inserting the battery car-
tridge. If the cartridge does not slide in easily, it is
not being inserted correctly.
Switch action
1
3
► 1. Switch trigger
CAUTION:
•
Before inserting the battery cartridge into the
4
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
Automatic power off
When the switch trigger is kept being pulled for three
minutes without driving screws or tightening bolts, the
tool automatically stops. To restart the tool, release the
switch trigger and then pull it again.
Reversing switch action
A
► 1. Reversing switch lever
CAUTION:
•
Always check the direction of rotation before
operation.
•
Use the reversing switch only after the tool
comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may dam-
age the tool.
•
When not operating the tool, always set the
reversing switch lever to the neutral position.
5 ENGLISH
B
1
Publicité
Table des Matières
