AEG MRC 4150 Mode D'emploi page 59

3. Connect the device with the power supply unit by plugging the jack of the power
supply unit into the "DC 5 V" jack.
CAUTION:
• This device should only be used with the mains supply unit (included). Do not
use it for other devices.
• Only use a 5 V power supply unit (
the device.
NOTE:
• Disconnect from mains power supply during longer periods of non-use.
• If you did not insert another reserve battery, the time and the station memory
will be lost as soon as the power supply is interrupted.
Inserting the reserve batteries
(Batteries are not included in the scope of delivery)
In case of power failure or if the power supply unit is pulled from the plug, the
settings are maintained if the reserve batteries are inserted.
1. Open the battery compartment on the bottom side.
2. Insert two type AAA / R 03 1.5 V batteries. Check that the polarity is correct (see
battery compartment).
3. Close the battery compartment.
WARNING:
The batteries shall not be exposed to excessive heat such as sunshine, fire or the
like. Danger of explosion!
CAUTION:
• Batteries can leak battery acid. If the device is out of use for a long period of
time, remove the batteries.
• Different battery types or new and used batteries must not be used together.
• Batteries are not to be disposed of together with domestic wastes. Dispose of
the used batteries at the relevant collection bin or at your dealer' s .
USB Charging Socket
You can charge your Smart phone through this jack. Use the USB cable of your Smart
phone for the connection.
MRC4150_IM_new2
English
). A different supply unit may damage
59
20.04.16