Cut Close To The Edge; Instructions For Use - GÖLZ ES350 Mode D'emploi

Système de tronçonnage
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ES350 / ES400
Installation and adjustment:
The depth scale is a guideline, designed for new diamond cutting discs with max. segment height.
The cutting depth decreases with wear of the segments.
The cutting depth has to been checked always by a trail
13.

Cut close to the edge

For cuts near the edge you need the adapter for cuts near the edge, including the protective plate, and the
diamond cutting disc for cuts near the edge (optional accessories).
Installation:
Remove the diamond cutting disc and remove the clamping flange from the work spindle.
Disassemble the protective plate of the protective cover and the dust protection flap (I),
including the spring.
Pull protection flap and spring together.
I
Use the 6 hexagon socket screws (M5x12) to connect the close to the edge adapter to the diamond cutting disc
for cutting close to edge. Attach the adapter with installed disc onto the work spindle, turn the locking screw
(M12x30) into the tapped hole of the work spindle, and then tighten it firmly.
Now install the protective plate supplied with the close to the edge adapter.
Always strictly observe the notes concerning tool change!
The adapter set for cuts close to the edge may be used only for cuts close to the edge!
For all other work, the closed protective plate, including the dust protection flap and the spring, must be
installed again.
When reconfiguring, clean all relevant parts.
14.

Instructions for Use

Exercise caution when cutting slots in structural walls; see Section "Information on Structures".
Clamp the workpiece if it does not remain stationary due to its own weight.
Do not strain the machine so heavily that it comes to a standstill.
After heavily straining the power tool, continue to run it at no-load for several minutes to cool
down the accessory.
Do not touch grinding and cutting discs before they have cooled down. The discs can become very
hot while working.
Protect the cutting disc against impact, shock and grease. Do not subject the cutting disc to lateral pressure.
First, remove the protective plate of the protective cover and replace it by the protective
plate belonging to the cutting depth limiting.
Use the two wing bolts to tighten the cutting depth limiting to the protective plate (refer
to the figure).
To set the desired cutting depth, loosen the two wing bolts, set the desired cutting
depth by means of the scale, and tighten the screws again by hand.
cut.
- 24-
5009016-00
BA-DE-GB-FR-NL (056)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Es400

Table des Matières