Operating The Light; Operating The Compressor - Cartrend 7740013 Mode D'emploi

4.2 Operating the light

▪ Press the green button
work light until it catches (locks).
8
The work light is now switched on.
▪ To switch the work light
press the green button
reset to its original position and the
light will turn off.

4.3 Operating the compressor

ATTENTION! Always wear
suitable ear protection and
suitable safety glasses when
using the equipment!
The air hose with valve quick
18
disconnect is located inside the
17
built-in storage compartment behind
the cover (see page 29, Image 3).
19
Always check the unit and air hose
for damage before use! Never use the
equipment if damaged! Always review
the manufacturer´s instructions for the
inflatable item before use.
Select the correct valve adapter. Open
the valve quick disconnect
pushing the quick disconnect lever
away from the air hose
the valve adapter and press the lever
towards the air hose to lock (see Image
5).
Image 5
GB
740013_PowerStation_Manual _25_09_2012_booklet_print
Dienstag, 25. September 2012 17:17:38
Car-, motorcycle- and bicycle tyres
with automotive valve (Schrader valve
for the
5
with 7.7 mm thread diameter) can be
inflated without adapter!
Do not operate the compressor for
off again
8
more than 10 minutes, then allow the
. It will then
5
unit to cool down for 20 minutes!
▪ No valve adapter required to inflate
▪ Open the valve quick disconnect
▪ Verify the car valve con-
▪ To activate the compres-
18
▪ Open the quick release valve
▪ Also check the air pressure using
by
17
. Now attach
18
▪ Then reattach the valve cap to the
car tyres. First remove the cap from
the tyre valve.
and attach the car valve connector
as far onto the tyre valve as possible
while closing the quick disconnect
valve.
nector is secure by care-
fully pulling on it.
sor press the compressor
Off / On switch to ( I ).
16
NOTE: the compressor
can be switched off at
any time by setting the compressor
switch to ( O ).
16
disconnect the auto valve connector
from the tyre valve.
another pressure gauge to determine
the precise value. If the desired air
pressure has not been reached,
repeat the process.
tyre valve.
17
Image 6
and
17
31