Panasonic TY-WK42PR20 Manuel D'installation page 15

6. Mounting the plasma display onto the
wallhanging bracket and connecting it to
the other components
 Remove the red-marked pivot fixing/releasing screws  on the
left and right (one at the left and one at the right).
 Fit the insulation spacers at the top of the plasma display onto
the cutouts at the top of the wall-hanging bracket, and lower
the plasma display.
 Pull the plasma display toward you as shown in the figure on
the right, and connect it to the power cord and the cables of
other components.
 After completing the connections, lift the plasma display
slightly, and insert the lower insulation spacer into the hole at
the lower part of the wall-hanging bracket.
 Now lower the plasma display.
CAUTION
• If the plasma display is lifted too much, its top part will become
disengaged from the wall-hanging bracket.
7. Anchoring the plasma display
 Install the accessory screws for securing unit  (2) into the
mounting holes of the screws for securing unit on the sides
(left and right) of the wall-hanging bracket.
 Securely tighten the removed red-marked pivot fixing/releasing
screws  (one at the left and one at the right) in the mounting
holes of the red-marked pivot fixing/releasing screws on the
sides of the wall-hanging bracket.
(Tightening torque: 1.2 to 1.5 N•m)
Note
• In order to prevent the plasma display from becoming disengaged
from the wall-hanging bracket, the screws for securing unit  must
be securely tightened at the left and right as far as their bases.
How to remove the plasma display from the
wall-hanging bracket
 Remove the screws for securing unit  (one at the left and one
at the right) which are mounted on the sides of the wall-hanging
bracket.
 Disconnect the power cord and the wires connecting the plasma
display to the other units.
 While lifting the bottom part of the plasma display, pull the plasma
display toward you.
 After the bottom insulation spacers have been removed, continue
lifting up the plasma display and remove it.
Note
• The plasma display needs to be lifted up approximately 4 cm (1.6
inches) to be removed.
Upper insulation spacer
 Red-marked pivot
fixing/releasing screw


Cutout
at top
 Red-marked pivot fixing/releasing screw
Screw for securing unit 
Hole for mounting the
screw for securing unit
Mounting hole for red-marked
pivot fixing/releasing screw
Wall-hanging bracket
Screw for securing unit 
Lower insulation
Hole at bottom


Lower insulation
spacer


spacer
15