M-system FD 96 Mode D'emploi page 198

CLOCK
(fig. 6.2)
1. Fig. 6.2 - Upon immediate connection
of the oven or after a power cut (black
out), the numbers on the programmer
display will flash.
2. Fig. 6.2 - To set the time, press button
for about one second; one hand
appears on 12.
3. Fig. 6.2 - Within 7 seconds press
or buttons to set the time of the
day (hours and minutes). Seven sec-
onds after the last selection, the sec-
onds hand appears on the display.
Note: If the clock is reset it deletes
any previously set program.
1
2
3
Fig. 6.2
198
2 seconds
or
MANUAL COOKING WITHOUT PRO-
GRAMMER
(fig. 6.3)
To manually use the oven, without the
programmer, the numbers on the display
do not have to flash and the inner hands
do not have to be lit (none semi-auto-
matic or automatic program set).
A. Fig. 6.3 - Programmer with a set pro-
gram. To cancel the set program
press button
inner hands disappears on the display
and the oven can be used in manual
mode.
B. Fig. 6.3 - Flashing numbers on the
display (normally after turning off the
buzzer which indicates the end of a
programmed cooking).
Press button. The numbers stop
flashing and the oven can be used in
manual mode.
Attention: At the end of the cooking
switch off the oven manually by turn-
ing the function and temperature con-
trol knobs to the "0" (OFF) position.
A
B
Fig. 6.3
for about 2 seconds;
2 seconds