Setting / Adjustment; Mains Connection; Saw Chain Change - Mafell ZSX Ec Notice D'emploi

Table des Matières

Les langues disponibles

- The riving knife/splitter 4 (Fig. 1) including the

guard plate for the bottom chain deflection 6 may

not be removed.

- The machine is a one-man tool and may only be

used for work during which the base plate 3 (Fig.

1) serves as workplate.

- Prior to carrying out any work, check whether the

tank contains oil for the chain lubrication and

whether the chain lubrication is working (see

section 4.4).

- Keep a firm hold on the machine already before

switching it on and support it. At the same time, rail

and chain must stand unobstructed. Only begin

cutting the workpiece when the saw chain has

achieved its full speed. Pay attention to a secure

footing.

- The switch may not be wedged in ON position.

- Never reach below the base plate or into the chip

ejector during sawing.

- Never transport the machine with running saw

chain and pay attention that, except for the

workpiece, the running chain does not come in

contact with adjacent objects.

- Never remove cover 12 (Fig. 1) covering the chain

pinion with the machine running and only for a tool

change and refit immediately afterwards.

- As the machine cannot be connected to an

exhaustion, it may only be used to work outdoors

or in sufficiently ventilated rooms.

- Once adopted, never change a cutting direction by

force. The saw must be guided such that the

pressure does not bring the chain to a stop.

- Examine the workpiece for foreign objects. Never

attempt to cut into nails or other metal objects.

- Always lead the connecting cable away from the

machine to the rear while sawing.

- Immediately pull the power plug in case of

damaged or severed connecting cables.

- Match the feed speed during sawing to the

material thickness. Feeding too fast results in an

overload of the motor, rough saw cuts and faster

blunting of the saw chain.

- Only remove the machine from the workpiece if the

saw chain has come to a standstill. Thanks to the

built-in brake, this happens very quickly.

Instructions on service and maintenance:

- Regular cleaning of the machine, in particular the

setting mechanisms for tilting the guides for the

parallel stop and the enclosure of the top and

bottom chain deflection, constitutes an important

safety factor. Pull the plug before starting this

work.

- Only original MAFELL spare parts and accessories

may be used. Otherwise, the manufacturer will not

accept any warranty claims and cannot be held

liable.