Muting The Sound; Using The Sleep Timer; Recording A Source - JVC RX-5060B Manuel D'instructions

The following basic operations are possible only using the
remote control.
TA/NEWS/INFO
SLEEP
REW FF
REC PAUSE CD-DISC
MUTING

Muting the Sound

Press MUTING to mute the sound through all speakers and
headphones connected.
"MUTING" appears on the display and the volume turns off (the
VOLUME indicator and its level indication go off).
To restore the sound, press MUTING again.
• Turning MASTER VOLUME on the front panel or pressing
VOLUME +/– on the remote control also restores the sound.

Using the Sleep Timer

Using the Sleep Timer, you can fall asleep while listening to music.
When the shut-off time comes, the receiver turns off automatically.
Press SLEEP repeatedly.
The SLEEP indicator lights up on the display, and the shut-off time
changes in 10 minutes intervals:
10 20 30 40
(Canceled)
OFF
To check or change the time remaining until the shut-off time:
Press SLEEP once.
The remaining time until the shut-off time appears in minutes.
• To change the shut-off time, press SLEEP repeatedly.
To cancel the Sleep Timer:
Press SLEEP repeatedly until "SLEEP OFF" appears on the display.
The SLEEP indicator goes off.
• Turning off the power also cancels the Sleep Timer.
Using the Sleep Timer
Muting the Sound
50 60 70 80 90

Recording a source

You can record any sources playing through the receiver to a
cassette deck (or a CD recorder) connected to the
TAPE/CDR jacks and the VCR connected to the VCR jacks at
the same time.
While recording, you can listen to the selected sound source at
whatever sound level you like without affecting the sound levels
of the recording.
Note:
The output volume level, Midnight Mode (see page 19),
Equalization patterns (see page 22), Surround modes and DSP
modes (see pages 23 to 26) cannot affect the recording.
Basic adjustment auto memory
This receiver memorizes sound settings for each source—
• when you turn off the power,
• when you change the source,
• when you change the analog/digital input modes, and
• when you assign the source name (see page 12).
When you change the source, the memorized settings for the
newly selected source are automatically recalled.
The following can be stored for each source:
• Analog/digital input mode (see page 11)
• Input attenuator mode (see page 12)
• Equalization pattern (see page 22)
• Speaker output levels (see page 22)
• Surround and DSP mode selection (see pages 23 and 26)
Notes:
• If the source is FM or AM, you can assign a different setting for
each band.
• A sound setting assigned for a digital component is valid for
both the analog and digital input modes.
13