Power On The Camera; Setup Menu; Viewing The Pictures - Bresser 9630200 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22

3.3 Power on the camera

Before switching on, please pay attention to the following:
1. Avoid temperature and motion disturbances in front of
the camera such as big leaf, curtain, air-conditioner, air
outlet of a chimney or other heat sources to prevent
false triggering.
2. The height from ground for placing the camera should
vary with the object size appropriately. In general, one to
two meters are preferred.
3. Slide the power switch to the ON position to power on
the camera.
After switching on the camera, the indicator LED (red) will
blink for about 10s. The 10s is a buffering time e.g. for
closing and locking the bottom cover, fixing the camera on
a tree and walk away. After 30 seconds the device starts
the autonomic capturing of pictures. If no SD card is insert-
ed, the device switches off automatically after 30 seconds.

3.4 Setup Menu

1. Press the „MENU" button to enter the settings menu.
2. Press the arrow keys UP or DOWN to select a menu item.
3. Press „OK" to edit the menu item.
4. Press the arrow keys UP or DOWN to change the value.
5. Press „OK" to confirm.
The following settings are available:
1. Date and time
2. Default (reset to default settings)
3. Format (format memory card. Caution: all data stored on
the SD card will be lost).
4. Sensitivity (adjust the sensitivity of the motion sensor)
low / medium / high
5. Stamp (timestamp)
6. Photo Size (image resolution)
2 MP / 3 MP * / 5 MP * (* interpolated)
7. Delay (trigger time until the next photo)
30 min / 15 min / 10 min / 5 min / 3 min / 1 min / 30 sec /
15 sec / 10 sec / 5 sec

3.5 Viewing the pictures

There are 2 ways to view the pictures:
1. Via the LCD screen on the device
To view the images stored on the SD card directly on the
LCD screen of the device, press one of the preview buttons
for a few seconds. The camera now changes to „Preview
Mode". Use the preview buttons to switch between the pic-
tures. The camera automatically exits „Preview Mode" if no
key is pressed for a few seconds.
EN
19

Publicité

Table des Matières
loading

Table des Matières