Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION MANUAL
SOLAR2R
Dual Technology Digicode
4] MOUNTING
Place imperatively the foam seal
5] PROGRAMMING
1. Reader configuration :
- On readers position the two dipswitchs to OFF,
unplug the reader and start again.
1 reader configuration :
- Press 1B, the reader is blue and position two dipswitchs to ON.
2 readers configuration :
- Press 1B on the reader 1 and 2B on the reader 2 then position the dipswitchs n°2 of two
readers to ON. On the reader that ends the RS485 link, the dipswitch n°1 must be to ON,
leave the dipswith 1 from the other reader to OFF.
2. Controller configuration :
To reset controller:
On the central bord, position dipswitch 1 to ON :
static green LED,
red LED + green LED.
Position dipswitch 1 to OFF : green LED flash.
To reset MASTER CODE :
Position dipswitch 2 to ON : static red LED .
Position dipswitch 2 to OFF : green LED flash.
3. Complementary information :
- Green LED flashes on the controller indicate that the connection between the reader
and controller is good.
- The tamper switch activates the relay of the alarm when the front panel is removed. The
readers are locked out. The red LED lights on with a permanent beep during the time of the
lockout.
- The EEPROM memory can be used to restore the memory in case of the product
substitution.
8
cdvigroup.com
/ Proximity Standalone
®
ON
ON
ON
OFF
1
2
ON
ON
ON
ON
ON
ON
OFF
OFF
1
2
1
2
ON
ON
ON
ON
ON
ON
OFF
OFF
1
2
1
2
EN
ON
ON
ON
OFF
1
2
ON
ON
ON
OFF
1
2
Publicité
Table des Matières
