Purpose Of Use; Work Area Safety - Beta 3029/2T Mode D'emploi

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
HYDRAULIC JACK, 2 T, WITH 4 WHEELS
OPERATION MANUAL AND INSTRUCTIONS FOR HYDRAULIC JACK MANUFACTURED BY:
BETA UTENSILI S.P.A. Via A. Volta 18, 20845, Sovico (MB) ITALY
Original documentation drawn up in ITALIAN.
CAUTION
Store the safety instructions with care and hand them over to the users.

PURPOSE OF USE

The hydraulic jack can be used for the following purposes:
• suitable for lifting means of transport
• functional and handy, for transportation - for example, on mobile workshops.
The hydraulic jack must not be used for the following operations:
• use as a support
• use under the vehicle that is being lifted
• lifting and/or moving people
• use for any applications other than those it has been designed for
• maximum loading capacity stated in TECHNICAL DATA table must not be exceeded.

WORK AREA SAFETY

For reasons of safety, the hydraulic jack must be used by one person.
Keep children and bystanders away from your workplace while operating the jack.
Distractions from other people can cause you to lose control over the jack.
Use the jack on a flat floor. Do not lift loads on sloping grounds.
Using the jack on soft, uneven floors may result in load instability.
Do not lift the load in narrow areas, not to run the risk of getting trapped.
Do not use several jacks on the same load simultaneously.
Do not stand under the load before placing it on suitable stands.
Before starting lifting operations, secure the vehicle with the emergency brake and/or place
two wedges at the wheels.
Before lifting a loaded vehicle, check that the load is stable.
While the jack is being used, the engine of the vehicle must be off.
6
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING THE
HYDRAULIC JACK. FAILURE TO COMPLY WITH THE SAFETY STAN-
DARDS AND OPERATING INSTRUCTIONS MAY RESULT IN SERIOUS
INJURY.
EN I