Accessories; Scrapping And Disposal; Improper Use - Beta 3067/70-13T Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
INSTRUCTIONS FOR USE

ACCESSORIES

- The jack is supplied with two extensions or height adapters (120 mm the long extension, 70 mm the short
extension), a circular tooth plate (10 mm plate) and an extension holder.
TING AS A CONSEQUENCEOF DISREGARD FOR THE ABOVE INDICATIONS AND THE WARRANTY CONDITIONS
ARE INVALIDATED THEREOF!

SCRAPPING AND DISPOSAL

- The lubricants must be disposed of in compliance with the anti-pollution laws in force.
- Scrapping the jack and its component parts must be carried out by the user in accordance with current laws.
USE
not to compromise its operation.
- Expressly observe the safety rules already described in this manual.
1. Position the jack under the supports as described in the manual of the vehicle
the manufacturing company is not responsible for any break or damage to the lifted vehicle or to persons or
property due to an incorrect use of the jack.
2. The handle positioning lever (1) is on the left in relation to the worker; by moving it upwards the stopping system is
released so the worker can then choose one of the three possible handle positions. DWG. 13
3. When control (2) is in the perfectly central position, the jack is in the idle status.
4. By turning control 2, located near the handle, towards the right in relation to the worker, the jack lifts the load.
5. By turning control B, located near the handle, towards the left in relation to the worker, the jack lowers the
load. DWG. 13
6. After lifting the load, it is absolutely essential to rest it on the support stands before doing any work under it.
REMEMBER THAT THE JACK IS A LIFTING DEVICE AND NOT A SUPPORTING DEVICE!!!
- The operator's employer will have to provide the necessary training and furnish the necessary information about the
pumping and shifting forces.
coupling of the air inlet and the distributor itself. DWG. 14
-

IMPROPER USE

The air-hydraulic jack has been designed and made to lift transport vehicles. Any other use of the jack, such as for
with the safety rules listed in this manual is considered to be improper use.
EN
-
9

Publicité

Table des Matières
loading

Table des Matières