Declaration Of Conformity - Beta 3029/2T Mode D'emploi

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
HOW TO USE HYDRAULIC JACK
Lift any vehicle as follows:
• Position the jack under such lifting point as recommended in the vehicle manufacturer's manual.
• The jack is fitted with a foot pedal which gives a faster approach to the lifting point.
• Pump the jack until the required height for the load is reached.
• After the vehicle has been lifted, secure it on appropriate axle stands, before carrying out any jobs
under the vehicle.
• Before lowering, lift the vehicle and remove the axle stands; pull the handle up
and turn it anticlockwise.
• The handle automatically returns to the initial position; hold the handle until the jack is lowered
completely.
Do not stand under the load before placing it on suitable stands.
Before starting lifting operations, secure the vehicle with the emergency brake and/or place
two wedges at the wheels.
• After the jack has been used, and if it is not used for prolonged periods, it should be completely down,
and it should be stored in a safe, suitable place.
DISPOSAL
The jack must be disposed of in compliance with the laws in force in the country where it is used.
WARRANTY
This equipment is manufactured and tested in accordance with current EU regulations, and is covered by
a 12-month warranty for professional use and a 24-month warranty for non professional use respectively.
We will repair any breakdowns caused by material or manufacturing defects by fixing or replacing the
defective pieces or replacing them at our discretion. Should assistance be required once or several times
during the warranty period, the expiry date of this warranty will remain unchanged. This warranty will not cover
defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition, this warranty will no
longer be valid if any changes are made, or if the jack is forced or sent to the customer service in pieces. This
warranty explicitly excludes any damage to people and/or things, whether direct or consequential.

DECLARATION OF CONFORMITY

We hereby declare, assuming full responsibility, that the described product complies with all the relevant
provisions of Machine Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN 1494
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845 Sovico (MB) ITALY

EN I
9