Bellman & Symfon Bridge BE1520 Mode D'emploi page 22

42
Troubleshooting in brief
Problem
Nothing happens when the transmitter is activated
with the test button.
The LED (1) blinks yellow when the Bellman Visit
868 Bridge is activated!
The LED (1) blinks green when the Bellman Visit
868 Bridge is activated but the receivers are not
responding.
Solution
• Check that the power supply unit is connected
correctly.
• If the power supply unit is not connected, change
the back-up battery. Only use an alkaline 6LR61 or a
lithium 6F22 type battery.
Make sure that the power supply unit is connected
correctly.
• Change the back-up battery. Only use an alkaline
6LR61 or a lithium 6F22 type battery.
Make sure that the power supply unit is connected
correctly.
• Check the batteries in the receivers.
• Check that the receivers are not placed too far
away by moving them closer to the Bellman Visit 868
Bridge.
• Check that the Bellman Visit 868 Bridge is set to
the correct Radio Key. For further information see
Function/Radio Key.
The receiver signals when no transmitter is activated. • Change the Radio Key on all units in the system.
1. LED. Combined transmission and back-up
battery indicator. For further information see
Indicators and Signals
2. Test button/pushbutton
3. Exterior External Trigger.
4. Signal Switch
For further information about the product in English, refer to the Appendix.
For further information see Function/Radio Key.
5. Radio Key Switch
6. Connector for power supply unit
7. Battery cover
8. Wallmount bracket
43
CZ
DE
DK
ES
FI
FR
GB
GR
HU
IT
NL
NO
PL
PT
SE
YU