Cleaning, Maintenance And Spare Parts - EINHELL PROFI Silver Line PS-PS 750 Laser Mode D'emploi

Anleitung PS-PS 750 Laser_SPK1
7. CLEANING, MAINTENANCE AND
SPARE PARTS
Always pull out the mains power plug before star-
ting any cleaning work.
7.1 Cleaning
Always pull out the mains power plug before star-
ting any cleaning work.
Clean the tool at regular intervals (remove all
dust, chips, splinters, etc.) We recommend that
you clean the tool immediately after you use it.
Clean the tool with a damp cloth and some soft
soap. Do not use cleaning agents or solvents;
these may be aggressive to the tool's plastic
parts. Ensure that no water can get into the interi-
or of the tool.
7.2 Maintenance
There are no parts inside the tool which require
maintenance.
7.3 Replacing the carbon brushes
Important! The carbon brushes should not be
replaced by anyone but a qualified electrician.
7.4 Ordering spare parts
Please provide the following information on all orders
for spare parts:
Model/type of tool
Article number of the tool
ID number of the tool
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
23.08.2005 10:23 Uhr Seite 19
GB
19