emerio UVC-127226.1 Mode D'emploi page 8

4. The appliance can be used with the water tank and cloth to mop the floor.
1) Make sure the cloth is attached at the back of the water tank. When the water tank switch (J) is at the
side "CLOSE", open the water tank lid (K) and fill the water tank with some water, then close it properly.
2) Make the wheel side of the floor brush be close to the magnets (M) on the water tank. The floor brush
and water tank will be combined together.
3) Press the water tank switch to the side "CLOSE", the water will not be flown out; press it to the side
"OPEN", the water will be flown out.
5. After use, press the power switch to turn off the appliance.
NOTE:

During use, please pay attention to the dust capacity and empty the dust cup before it is full.

The suction hole opening must be open and free of any obstructions at all times. Otherwise, the motor
will overheat and could become damaged.

The appliance in upright state will not work, if the handheld cleaner body has not been properly
assembled below the upper handle.

The 2 in 1 nozzle can be stored at the back of handle when it is not in use.
CLEANING AND MAINTENANCE
1. Turn off the appliance and disconnect it with the adaptor before dissembling, assembling or cleaning.
2. Do not immerse the main unit and battery in water or any other liquids.
3. Use only a soft moist cloth to clean the outside of the main unit. Do not allow any kind of liquid to enter the
main unit.
4. Do not use aggressive chemicals or abrasives.
5. Do not use the device if the filter is broken or worn out.
6. The unit does not contain parts serviceable by you, do not disassemble it and do not try to repair it yourself.

How to clean the dust cup
1) Turn off the appliance. Take off the handheld vacuum cleaner.
2) Press the dust cup release button (N) to take off the dust cup (P).
- 7 -