Safety - Bartscher ID091M01 Manuel D'installation, D'utilisation Et D'entretien

3.

SAFETY

Read carefully the guidelines and
instructions in the instruction manual
before you use the appliance.
The instruction manual
information on how to safely use and maintain the
appliance. Retain the manual for future reference.
Electric installation conforms to CEI EN
60335-1 and 60335-2-36 regulation.
To prevent any hazard, the damaged
mains power cable may be replaced by the
manufacturer or service personnel only.
The manufacturer took extra care when designing
and manufacturing to prevent any safety or health
hazard to the personnel operating the appliance.
Please read carefully the guidelines in the
instruction manual and instructions placed directly
onto the appliance. Above all, observe all the
safety instructions.
Do not intervene in or remove the protective
devices installed in the appliance. Non-
compliance may lead to severe safety and health
hazard against people. We recommend to perform
a few tests to know the layout and main functions
of the control panel, particularly those to switch
the appliance on and off.
The appliance is intended only for the use it has
been designed for and any other use is
considered as the use not in compliance with the
intended use.
The manufacturer is not liable for material
damage or damage to person caused by
misapplication or incorrect application of the
appliance.
Any maintenance work that requires special
technical license or special skills may be
performed by qualified personnel only.
contains general
3
To provide hygiene and protect foods from dirt, all
the elements that have direct or indirect contact
with the foods and all border areas must be
thoroughly cleaned. Use only the cleaning agents
intended for use in contact with food and avoid
using flammable agents or harmful to health.
After each use of the appliance make sure that all
the heating elements and control elements have
been switched off and the cable unplugged.
In case of prolonged interval in using the
appliance disconnect all power supply cables and
thoroughly clean the inside and outside elements
of the appliance.
In direct connection to the mains
the safety switch should be supplied
where wire joints dilation is large enough
to secure disconnection in category III
overvoltage, which is in accordance with
the installation rules.
To prevent any risks, the damaged
supply cable must be replaced only by the
manufacturer or electrician.
The device requires some safety
measures during installation, positioning, fixing,
and connecting to the power supply. See
chapter 8 „INSTALLATION").
Do not clean the device with direct
stream of water.
If the surface of the glass hob is
broken, immediately disconnect the device
from the power supply.
Do not place any plastic containers on
hot surfaces of the glass hob.
In order to avoid overheating, do
not place any aluminum foil or metal
plates on the surface of the device.
ENGLISH
GB